Hardwood Floor Finishes

Does Your Hardwood Floor Finish Need Reapplying?

It's only been a few years and you see that your hardwood floor looks seemingly old. What happened? How can you make it look like new again? Before you take any step further, you should first see the condition your hardwood flooring is in. Check if any special cleaning is necessary or if serious repairs need to be done.

When evaluating the condition of your hardwood floor, observe the finish. Is it just soiled or has it already thinned out? Study your floor to see if the finishing has been scraped, dulled, or chipped.

You can find out if your finish is worn by spilling a small amount of water at a high-traffic area. If the water beads at the top, then you have nothing to worry about -- the finish is still intact and sealed. But if the water seeps in and darkens the spot where it landed then you might need to redo the finishing for that particular area. If the test bears the same result for other parts of the house, then those probably need replacing, too.

Next, see if the wood is still in good condition. If the finish has shown signs of wear, it is likely that the wood has been damaged, too. If you find that the wood has started to decay, then you definitely need to replace the boards.

If it's a situation that still can be salvaged, it would be best to just call in professionals, as a do-it-yourself endeavor, especially if you're not that experienced, to avoid causing further damage.

You can try to temporarily resolve the damage by putting wax on the affected area. Take note of the word 'temporary' because wax is by no means a solution to woodwork problems. It simply acts as a coverup or maintenance coat until you can come up with the funds to put in replacements.

It does not take rocket science to know if your floor's finish needs to be redone. But, while this is easy to determine, the fact that refinishing jobs are costly might put you off. But if you want to restore your hardwood floor's beauty, then you should set a budget for repairs aside. Otherwise, your initial investment on your flooring will go to waste.


   

Super Floor Center Free Thermal Underlayment

                                                                                                           

 

More Articles

 

 

Search This Site

 

Related Products And FREE Videos






More Articles


Cleaning Hardwood Floor

... burns and scratches, sanding the area lightly and then reapplying a coat of finish will make your floor as good as new again. If sticky chewing gum is your problem, then you should ice the deposit first until it becomes brittle enough to crumble off. For hardheaded gums, try pouring floor cleaner around ... 

Read Full Article  


Distressed Hardwood Floor

... you are likely to see the same scrapings at another part of the floor. The variety of scrapings on factory made distressed floors is limited, whereas if done by hand, the designs are limitless. When choosing a distressed hardwood floor, realize that distress connoisseurs can easily spot a fake. Thus, ... 

Read Full Article  


How To Lay Hardwood Floor

... finally decided on its placement, that's when you drive 2-inch nails to secure it. Use a nail set to drive the nails' heads a little below the surface so they don't jot out. 6) Sand the area to even the surface out and apply a finish that matches the rest of the hardwood floor. Now you know how to lay ... 

Read Full Article  


Finishing Hardwood Floor

... creates a dark stain, then it's a sign that your coating has faded and you need to refinish soon. But if it forms small beads, then you have no reason to panic. Your floor coating is still intact. Do the same procedure at different parts of the house, especially areas that experience heavy traffic. There ... 

Read Full Article  


Repairing Hardwood Floor

... handle. In this case, you will need to replace the hardwood board that has been destroyed. Again, there is no need to phone the specialists for this job because it is something you can manage yourself. What you should do is take out the damaged board, get a new plank that's of the same size and lay it ... 

Read Full Article