Prefinished Hardwood Floor

Have It Easy With Prefinished Hardwood Flooring

Let's admit it. Installing hardwood flooring is quite a task and not many do it yourselfers succeed perfectly during their first try. True, installing hardwood flooring is a skill, but it can be less of a chore and a headache if you go with prefinished hardwood flooring in the first place.

Prefinished means it has already been coated and sealed with translucent film which serves as its protection from daily wear. What finishings can do is shield your hardwood floor from spills and scratches, and make it easier for you to wipe or mop clean.

If you're thinking of installing hardwood flooring yourself, you can enjoy the greatest ease and convenience with prefinished planks. With prefinished hardwood floors, the task of nailing the flooring to your subfloor ends after the drilling is done.

If you purchased pure hardwood oak or maple (or whatever is available), you will have to apply finishings, sand it down and put on wax and polishers after. The amount of time to perform the task of installing a hardwood floor is halved if prefinished wood is used.

Prefinished floors also have a better finish than most independently finished floors. Because the application is uniform and the volumes of coating controlled and predetermined, you are sure that every prefinished hardwood floor plank is of the best quality. Normally, prefinished floors are thrice sanded and coated with aluminum oxide finish eight times. They are also likely to have been tested for various normal wear situations and made more resilient.

Prefinished flooring is a little more expensive than pure hardwood planks. However, when you do the math on everything that has to be done to make the basic form shine to your liking, you'll actually eventually spend a lot more with the latter, not to mention the heavy labor that you need to put into it.

Sure, you can argue that you can always hire professionals to do the job for you, but if cost is an issue, then you'll be thanking the high heavens that somebody had enough foresight to come up with prefinished hardwood flooring. Be a wise and practical consumer. Sanding and finishing entire floorings is a thing of the past. Now that prefinished floors are available, you should spare yourself from the hassle.


   

Super Floor Center Free Thermal Underlayment

                                                                                                           

 

More Articles

 

 

Search This Site

 

Related Products And FREE Videos






More Articles


Hardwood Floor Stain

... your floor, you might be tempted to replace the entire plank to get rid of it. This is not always the remedy. You should first try if it's a problem that can be remedied by sanding and refinishing the affected spot. Taking care of a small spot yourself will not be a nuisance, compared to changing the ... 

Read Full Article  


How To Lay Hardwood Floor

... new one. YOu might initially think that floor board replacement is a job that is reserved only for the professionals. In fact, laying a floor board is actually something you can do yourself, given the right tools and the proper instructions. There are hardware stores that sell bundled packages for do ... 

Read Full Article  


Repairing Hardwood Floor

... repair techniques to handle. In this case, you will need to replace the hardwood board that has been destroyed. Again, there is no need to phone the specialists for this job because it is something you can manage yourself. What you should do is take out the damaged board, get a new plank that's of the ... 

Read Full Article  


Hardwood Floor

... surroundings to keep us sane. Too much artificial building materials might seem ho-hum in the long run. Finally, in order to enjoy the full benefits of hardwood floors, proper care must be employed. They should be cleaned out constantly and maintained with waxing and refinishings to protect their quality. ... 

Read Full Article  


Discount Hardwood Floor

... flooring. Placed against the regular hardwood floors that are available in the market today, these materials are around 30% to 40% cheaper. Thus, if you're working under a tight budget, you can scour the Internet for them. You may also want to check out local hardware stores to see if they are puting ... 

Read Full Article